Electrician Greenwood
Along the leafy streets off Hepburn Avenue, Greenwood’s 1980s brick-and-tile family homes were wired for a very different era. Original switchboards near Warwick Grove and the train station on the Joondalup line now carry induction cooktops, ducted air conditioning and busy home offices, and they often struggle. Our licensed Perth electricians work these settled northern streets every week, upgrading tired boards, adding circuits, chasing nuisance trips and bringing older wiring up to a safe, modern standard for families who have held their block here for decades.
Call our team on 1300 632 094 for a straight answer, an upfront quote and a licensed sparky who turns up on time across Greenwood and the surrounding northern suburbs.
Same Day Trades Electricians in Greenwood
Greenwood sits in Perth’s established northern belt, a settled 6024 pocket of 1970s and 1980s brick-and-tile homes on generous blocks. The streets run leafy and quiet between Warwick Grove shopping and Hepburn Avenue, with the Joondalup line station putting the city within an easy commute. Same Day Trades works these roads most weeks, from the pockets bordering Woodvale and Kingsley through to the edges near Warwick and Carine, so we know the housing stock and the wiring behind the walls.
Most homes here were built for a household that ran a fraction of the appliances a modern family plugs in, which is why the switchboards and circuits show their age. As part of our wider team of licensed Perth electrical team, we match the fittings and upgrades to the vintage of your home rather than a one-size approach. From a single power point to a full board replacement in an older Greenwood home, we handle residential work of every size.
Switchboard upgrades for Greenwood’s original boards
A good share of Greenwood homes still run the ceramic-fuse or early plastic board fitted when the suburb went up in the 1980s. Those boards were never built for an induction cooktop, ducted air conditioning and a second fridge in the garage all pulling at once, so they run warm and trip when the load climbs. Rewireable fuses also miss the safety switch protection expected on circuits today.
We replace tired boards with a modern enclosure, fit the right number of circuits and label each one clearly. Our switchboard upgrade work lifts the board to current WA standards and adds RCD protection across power and lighting. If your board hums, smells hot or drops out whenever the kettle and toaster run together, book a replacement before it lets go.
Safety switches and RCD protection on every circuit
State rules call for at least two RCDs covering the power and lighting circuits in a home, and they must be in place before a property is sold or leased. Plenty of older Greenwood homes still run one safety switch, or none, which leaves whole circuits open to a live fault that could deliver a serious shock to anyone in the house.
We test the safety switches you already have, replace any that will not trip and add RCDs on circuits sitting unprotected. A working safety switch cuts power in a fraction of a second the moment it senses current leaking to earth. If yours keeps dropping out, that points to a real fault worth tracing, and we track down the cause rather than resetting it and walking away.
Adding power points without the double-adaptor mess
Homes built around Hepburn Avenue in the 1980s came with a handful of outlets per room, so power boards and double adaptors end up hanging off every wall in a busy household. Extra points through the kitchen, bedrooms, study and alfresco spread the load across more circuits and clear the tangle of leads running across the floor.
Our power point installation covers standard double outlets, USB points, weatherproof sockets for outside and dedicated circuits for ovens, air conditioners and car chargers. For the home offices that have become common near the Greenwood station commute, we add well-placed points so a desk setup is not run off a single overloaded socket. We run cabling neatly, patch behind us and test every outlet before packing up.
LED downlights and brighter lighting through the house
Swapping old halogen downlights for LED is one of the quickest ways to trim a Greenwood power bill and take heat out of the ceiling space. Halogens burn hot, dim with age and fail often, while modern LEDs draw a fraction of the power and keep going for years across kitchens, living zones and hallways.
Our lighting installation runs from downlights and pendants to garden, sensor and security lights, plus full room fit-outs during a renovation. In the older open-plan kitchens common through these 80s homes, we plan the layout, set the colour temperature and place switches where they suit how you actually move through each room. Damp-rated fittings go under eaves and patios so they hold up outdoors.
Ceiling fans for those warm northern-suburb summers
Perth summers stretch long and hot, and the afternoon breeze does not reach every room of a Greenwood home evenly, so ceiling fans earn their keep through bedrooms, living areas and the alfresco. A well-placed fan keeps air moving, eases the load on the air conditioner and holds down running costs across the hottest stretch from December into March.
Our ceiling fan installation covers new fans, replacements and fans with built-in lights, wired to a wall control or a remote. We fix the mount solidly to the ceiling structure so there is no wobble, and we can run a fresh circuit where none exists. Outdoor models rated for the elements go on patios so the motor and blades hold up season after season.
Rewiring older Greenwood homes with tired cabling
Some original Greenwood homes still carry the wiring they were built with, and after four decades the insulation on that cabling turns brittle and starts to crack. Roof heat and the occasional rodent push it along. Flickering lights, warm switches, browning outlets and repeat trips are the usual signs the cabling behind the plaster has run its course and needs attention.
Our house rewiring replaces old cabling circuit by circuit or across the whole home, brings in modern safety switches and lifts everything to current standards. We stage the work to keep power on where we can, so only part of the house is affected at a time. A full rewire is also the right moment to add the outlets and circuits a modern family actually uses.
Fault finding when the power keeps tripping
A dead outlet, half the house with no lights, or a breaker that drops the instant you reset it all point to a fault tucked away somewhere in the wiring. In these older Greenwood homes, moisture creeping into an outdoor fitting, a failing appliance or a corroded connection in the roof is a common culprit that a quick look will never turn up.
Our electrical fault finding traces the problem to its source with proper test gear instead of guesswork, so your money goes on fixing the real fault rather than swapping parts at random. We work through circuits, connections and fittings in order, tell you plainly what has failed and price the repair before we get on with it.
After-hours and emergency electricians near Warwick Grove
Power trouble pays no attention to the clock, and a burning smell at the board, sparks at an outlet or half a Greenwood home going dark on a hot night needs someone out fast. Storms rolling across the northern suburbs can knock supply about and damage a board, and standing water near a fitting can turn a small fault into a genuine danger.
Our emergency electrician service takes Greenwood calls around the clock and makes the situation safe before anything else. We isolate the danger, find the fault and carry out a repair that lasts rather than a patch that fails again next week. If you smell burning, see sparking or lose power to part of the house, switch off at the board and call.
Hardwired smoke alarms that meet current rules
State rules call for working smoke alarms throughout every home, and any alarm fitted now has to be mains powered and interconnected, so when one sounds the whole set sounds together. Battery-only alarms no longer meet the mark when a property changes hands, and a fair few older Greenwood homes near the station still rely on them.
We supply and fit mains powered, interconnected photoelectric alarms, positioning them properly across bedrooms, hallways and the main living areas. That interconnection matters most overnight, when an alarm at the far end of the house can rouse a sleeping family in time. We check the placement, wire each unit back to the board and confirm every alarm sounds as one.
Oven and cooktop wiring for kitchen upgrades
Kitchen renovations come up often in Greenwood as owners open up the original galley layouts, and a new oven or induction cooktop usually needs its own dedicated circuit rather than a shared one. An induction unit in particular draws heavily, and running it off cabling meant for a smaller old cooker is a fast way to nuisance trips or an overheated connection.
We run the correct dedicated circuit back to the board, size the cable to the appliance and check the board can carry the extra demand before we start. Where the switchboard is already stretched, we flag that first so the new kitchen runs without dropping out. Every connection is tested and left tidy once the appliance is in and working.
Hot water system wiring and changeovers
When a hot water system fails in a Greenwood home, the electrical side is often part of the job, whether it is a storage element on a controlled circuit, a heat pump or a changeover to a different unit. Older homes here sometimes run the tank on a tariff circuit that needs checking and rewiring when the system is swapped over.
We wire new and replacement hot water systems, sort out the controlled-supply connection and make sure the circuit and isolation switch match the new unit. If your hot water has gone cold and the element or thermostat looks to be the cause, we test the electrical side and get you back to hot water without guesswork. All work is left compliant and tested.
Renovation circuits for extensions and alfrescos
Greenwood’s generous blocks give owners room to extend, and a new room, alfresco or second living zone almost always needs fresh circuits rather than a spur off an existing one. Adding load to cabling already stretched across an older home is where trouble starts, so we plan the circuits properly around the finished layout.
We work in with your builder or handle the electrical side of a smaller renovation ourselves, running new power and lighting circuits, outdoor points and any dedicated supply the extension needs. Where the board cannot take more circuits, we sort the upgrade as part of the job. The result is a renovation that runs on wiring built for the extra demand, not one patched onto the original.
EV charger installation for the driveway
More Greenwood households are charging an electric car at home, and a standard outlet is slow and hard on an ageing circuit. A dedicated wall charger fills the battery far quicker and safely, drawing on its own protected circuit rather than sharing power with the rest of the garage or carport.
We fit home EV chargers from the common brands, run the dedicated circuit back to the board and check the board can carry the extra draw before we begin. Where an older Greenwood board is already stretched, we flag an upgrade first so the charger runs without nuisance tripping. We position the unit to suit your driveway, garage or carport and set it up so day-to-day charging is fast and safe.
Data, TV and network points for the home office
With the Greenwood station making the city commute easy, plenty of locals now split the week between the office and a room at home, and patchy wireless in a solid brick house does not cut it for video calls. Hardwired data points give a stable connection where it matters, at the desk, the media unit and the study.
We run network cabling, fit data and TV points and tidy the connection back to a central spot so the setup is neat and reliable. Aerial and antenna points get sorted at the same time where reception through the older homes has always been marginal. Everything is tested and labelled, so you know which outlet feeds what without tracing cables through the roof.
Surge protection for sensitive home electronics
A modern Greenwood home is full of electronics that a spike can wipe out in an instant, from the home-office gear and the television to the induction cooktop and air conditioning boards. Summer storms across the northern suburbs and the odd grid fluctuation are enough to send a surge through the wiring and damage anything plugged in at the time.
We fit surge protection at the switchboard to catch spikes before they reach your circuits, and add point-of-use protection on the gear that matters most. Paired with a modern board and proper earthing, it takes a real bite out of the risk. If you have already lost appliances to a storm, it is a straightforward addition worth making at your next board upgrade.
Frequently Asked Questions
It depends on the job, the parts involved and how long the work runs, so we price each job on its own before we start. There is no call out fee to come out and assess the work, and the figure we agree upfront is the figure you pay, with nothing extra tacked on once the job is finished.
Yes. In Western Australia electrical work must be carried out by a licensed electrical worker. Unlicensed wiring breaks the law, puts people at risk and can void your home insurance if it causes damage. Same Day Trades is fully licensed and insured, and we issue the compliance paperwork on every job we complete in Greenwood.
Often, yes. We keep vans working across Greenwood and the northern suburbs, so an early call usually means we can reach you the same day. For genuine emergencies we attend around the clock. Phone 1300 632 094 and we will tell you the soonest we can be at your door.
We cover all of Greenwood and the surrounding northern suburbs, including the streets bordering Warwick, Woodvale, Kingsley, Duncraig and Carine. Whether you are near Warwick Grove, off Hepburn Avenue or close to the train station, a local electrician can reach you. Phone us and we will confirm we work your street.
Yes. Our emergency team answers Greenwood calls day and night, weekends and public holidays included. If you smell burning at the board, see sparks at an outlet or lose power to part of the house, switch off at the board and call 1300 632 094. We make the situation safe first, then locate and repair the fault.
Yes. Western Australian law requires at least two RCDs, or safety switches, protecting the power and lighting circuits in a home, and they must be fitted before a property is sold or leased. Many older Greenwood homes fall short. We test the ones you have and add RCDs wherever circuits are left unprotected.
Yes. Alongside family homes, we look after rental properties, strata complexes and small commercial sites around Greenwood. For landlords and agents we handle RCD and smoke alarm compliance before a lease, along with repairs and fit-outs. We can bill and report the way agents and strata managers need, and we quote every job upfront.
Always. We look over the job, explain what is involved in plain terms and give you a firm price before any work begins. There is no call out fee to come and assess it, and the quoted price is what you pay. With the full cost laid out in front of you, the decision to go ahead is yours.
The regulars are switchboard upgrades on 1970s and 80s homes, renovation rewires, extra power points and LED downlight swaps. Ceiling fans for the summer heat and fault finding on tripping circuits come up often too, along with oven and cooktop wiring for kitchen upgrades and safety switch work for sales and leases.
Yes. Every electrician we send is fully licensed and insured, and all work meets the wiring rules and Western Australian standards. We hand over compliance paperwork once the job is done and leave the work tested, tidy and safe. You can book knowing the person we send is qualified to do your job properly.
Greenwood WA 6024 Service Area
Same Day Trades services Greenwood 6024 and all surrounding suburbs across Perth.
